Basic engineers view-only diagnostic GUI

[TerryJC]

Works OK on my Android phone.

[hamishmb]

Ah good. Does it work for you, Penri?

[Penri]

Apologies, the notifications just don't get through.

It look fine on my iPhone, thank you.


Penri

[hamishmb]

Glad it looks okay. I'll make my extra mods and then call it done then I guess.

Perhaps try unsubscribing and then re-subscribing and check junk/spam? After there's one new post in a thread, the forum won't notify you again for that thread until you've visited the page when logged in. It's a bit of an annoying notification system but I don't think I can change it.

[hamishmb]

I have finished my remaining changes for the Engineer GUI. I have not updated the version on this webserver as the interface has not changed.

This is now ready to be deployed with the NAS box when the rest of the software is complete. The only thing left to do will be to add all the reading-and-control table entries when we decide what pis we include in our initial deployment of the NAS box.

[Penri]

Hamish

Thank you, looking forward to using it.


Penri

[hamishmb]

I've done a minor update to the engineer GUI today, namely adding the rest of the tables, and changing the way it sorts the data to make it easier to see (the G3 site was a bit of a mess). I'll summarise this properly later on in the general software improvements thread.

It doesn't look or work very differently at all, but if you want me to deploy it on this webserver again, let me know and I will do so.

[TerryJC]

I presume that once the NAS Box has been installed you will want to deploy this on the WMT-Webserver on site?

[hamishmb]

Actually this was intended to be deployed directly on the NAS box using its built-in webserver, but with some minor modifications it could indeed go on the WMT-Webserver.

Any preference?

[TerryJC]

No. It's probably simpler to deploy it from the NAS Box.